Dafo Fomtec

Request Cart:

0 item(s)

Search the site

You are here:

Simulation foams

EnviroSenze products are environmentally friendly foam mimic concentrates with non-foaming properties. They are designed to be used when testing and commission foam systems. The foam mimic concentrate has been designed to have similar flow behaviour as traditional foam concentrate but has no foaming agents inside.
The foam mimic concentrate can also be used to determine induction ratio as measured by conductivity. The same foam mimic concentrate can be used for 1%, 3% and 6% systems. The lower detection limit is around 0,2% induction using ordinary tap water. The viscosity variates in the products.

  • EnviroSenze 10

    EnviroSenze 10 is an environmentally friendly foam mimic concentrate with non-foaming properties. It is designed to be used when testing and commission foam systems. The foam mimic concentrate has been designed to have similar flow behaviour as traditional foam concentrate but has no foaming agents inside. The foam mimic concentrate can also be used to determine induction ratio as measured by conductivity. The same foam mimic concentrate can be used for 1%, 3% and 6% systems. The lower detection limit is around 0,2% induction using ordinary tap water. The viscosity of EnviroSenze 10 is set be around 10 mPas. This mimics a typical AFFF foam concentrate with low viscosity. The viscosity is approximate and can vary from batch to batch. Since viscosity also changes by temperature it is advisable to always measure the viscosity of the foam mimic solution before use.
  • EnviroSenze 800

    EnviroSenze 800 is an environmen-tally friendly foam mimic concentrate with non-foaming properties. It is designed to be used when testing and commission foam systems. The foam mimic concentrate has been designed to have similar flow behaviour as traditional foam concentrate but has no foaming agents inside. The foam mimic concentrate can also be used to determine induction ratio as measured by conductivity. The same foam mimic concentrate can be used for 1%, 3% and 6% systems. The lower detection limit is around 0,2% induction using ordinary tap water. The viscosity of EnviroSenze 800 is set be around 800 mPas. This mimics an alcohol resistant foam concentrate in the lower viscosity range. The viscosity will not be exactly 800 mPas, but rather around this value. The viscosity can vary from batch to batch between 700 and 900 mPas. Since viscosity also changes by temperature it is advisable to always measure the viscosity of the foam mimic solution before use.
  • EnviroSenze 2500

    EnviroSenze 2500 is an environment-tally friendly foam mimic concentrate with non-foaming properties. It is designed to be used when testing and commission foam systems. The foam mimic concentrate has been designed to have similar flow behaviour as traditional foam concentrate but has no foaming agents inside. The foam mimic concentrate can also be used to determine induction ratio as measured by conductivity. The same foam mimic concentrate can be used for 1%, 3% and 6% systems. The lower detection limit is around 0,2% induction using ordinary tap water. The viscosity of EnviroSenze 2500 is set be around 2500 mPas. This mimics an alcohol resistant foam concentrate in the lower viscosity range. The viscosity will not be exactly 2500 mPas, but rather around this value. The viscosity can vary from batch to batch between 1500 and 3000 mPas. Since viscosity also changes by temperature it is advisable to always measure the viscosity of the foam mimic solution before use.